Lakhasly

1.Select Tensile Test.Open the software (click the icon Gunt wp300_20).Screw down the gripping head with the short bolt at the bottom and with the pressure pad.Tighten the nut on the upper gripping head by hand until gripping head is seated without slack in the upper cross member.Click TARE until all measured value reads Zero.Twist out the hand wheel on the master cylinder as far as it will go and move the load frame down to is lowest position.2.3.8.9.10.11.Click start 12.

1. Twist out the hand wheel on the master cylinder as far as it will go and move the load frame down to is lowest position.


2. Screw down the gripping head with the short bolt at the bottom and with the pressure pad.


3. Gripping head with the long bolt at the top


4. Insert the required tensile sample


5. Measure and note down the test length Lo of the sample between the two marks


6. Fix the sample by hand into the lower gripping head as far as the end stop


7. Fix the sample into the upper gripping head as the end stop, by rotating the gripping head itself.


8. Tighten the nut on the upper gripping head by hand until gripping head is seated without slack in the upper cross member.


9. Switch on the computer. Open the software (click the icon Gunt wp300_20). Select Tensile Test.


10. Click TARE until all measured value reads Zero.


11. Click setting and enter the required value. Click start


12. Apply load by slowly and constantly loaded by rotating the hand wheel.