Lakhasly

3.Change the manual regulation ratio in software to 1.9V and start recording the time using the timer.V.3 71 ENGINEERING TECHNOLOGY DEPARTMENT V.3 72 a. Go to your computer, open Gunt software, and switch to the "RT 634 Pressure Control Demonstration Unit" mode by clicking the arrows in the dialogue box as shown in Figure 6.4 (a). b. Click on "Charts" button as shown in Figure 6.4 (b).c. Set the "Software Controller" to "Manual" as shown in Figure 6.4 (c). d. In the "Manual Regulation Ratio" box, the maximum and minimum values that can be fed are 0V to 10V which corresponds to the 0% to 100% opening of electrical proportional valve (9) as shown in Figure 6.4 (d).For this purpose, a step in control value is applied to the system in the non-regulated mode and the system's response observed.Fully close the extraction valve (8) by turning it clockwise and then open it less than 1/4th by turning the knob 25 degrees in counter clockwise direction.Figure 6.4 Gunt Software Interface with steps 7.Ask instructor to check.Procedure 3.1.1.2.3.4.5.6.8.9.

3. Procedure
   3.1. Step Response of the System
   This experiment is intended to ascertain the properties and response of the control system underlying
   the model. For this purpose, a step in control value is applied to the system in the non-regulated mode
   and the system’s response observed. The procedure as following.


4. Make sure the apparatus has a compressor connected to it via a hose and the equipment is ready to
   use. Ask instructor to check.


5. Turn on the demonstration model via its main switch (10).


6. Turn on the compressor and wait until the pressure level in gauge 7b reaches somewhere between 5
   and 6 bar.


7. Make sure the throttle valve (3) is fully open.


8. Fully close the extraction valve (8) by turning it clockwise and then open it less than 1/4th by turning
   the knob 25 degrees in counter clockwise direction.


9. Prepare a stopwatch or open a stopwatch app on your phone for time calculations, then follow these
   steps.
   V.3 71
   ENGINEERING TECHNOLOGY DEPARTMENT
   V.3 72
   a. Go to your computer, open Gunt software, and switch to the “RT 634 Pressure Control
   Demonstration Unit” mode by clicking the arrows in the dialogue box as shown in Figure 6.4 (a).
   b. Click on “Charts” button as shown in Figure 6.4 (b).
   c. Set the “Software Controller” to “Manual” as shown in Figure 6.4 (c).
   d. In the “Manual Regulation Ratio” box, the maximum and minimum values that can be fed are 0V
   to 10V which corresponds to the 0% to 100% opening of electrical proportional valve (9) as shown
   in Figure 6.4 (d).
   Figure 6.4 Gunt Software Interface with steps


10. Using the software, start data sampling at 2 seconds interval and update the file name. Never delete
    the old files, always start new section. (Refer to Appendix: Automatic Data Logging).


11. Change the manual regulation ratio in software to 1.9V and start recording the time using the timer.


12. Monitor the pressure in tanks by means of the two pressure gauges (2 and 5). After a certain time,
    the pressure assumes a constant value. Stop the timer, take pictures of the gauges for your report,
    and fill the table below.